Note: To refresh your position:
• Select Position — the radio refreshes its position automatically
• Press Refresh
Changing GPS Accuracy
Procedure:
1 From the home screen, press the MENU key.
2 Select More . . . → Location → Accuracy.
3 Select one of the following:
• Medium (default) — Power consumption optimization is combined with less position accuracy.
• High – Better position accuracy is combined with less power consumption optimization.
Note: If connected to an external charging device, the radio automatically enters the High mode.
Packet Data
The Packet Data (PD) Service allows you to transfer data in a TETRA system using the Internet Protocol (IP).
Note: To transfer data from a standard computer over the air, connect the computer via the data cable
PMKN4025 with your radio. Your service provider has to setup additional applications on your computer.
If set up by your service provider it is possible to accelerate the transmission by using the Multi-Slot Packet Data
(MSPD) Service.
Note: This is a selling feature.
Viewing Data Statistics
Procedure:
1 From the home screen, press the MENU key.
2 Select More . . . → Packet Data.
Note: Data services are only available in TMO Mode. The data option must be set to Voice & Data or
Data Only.
3 Select one of the following:
• Sent Data — the number of KBs sent and throughput since current Packet Data activation is displayed.
• Received Data — the number of KBs received and throughput since current Packet Data activation is
displayed.
• Bandwidth — active data session percentage is shown.
• Failed Transfer — the percentage of failed sent/received packets.
Note: N.A. — standby packet data session.
100 | Main Menu
Send Feedback | |
To Next Page
Loading...
