Setting Backlight
When and where to use: To save the battery power.
Procedure:
1 From the home screen, press the MENU key.
2 Select Setup → Display → Backlight.
3 Select one of the following:
• Auto – backlight is triggered by turning on the radio, by pressing any key on the device or on the accessory
that is connected to it. Also charging or getting signal from the services like: Call-Out message, RUA request,
DGNA and TX timeout during priority call are going to turn on the backlight.
• Semi Auto – backlight is turning on when you are switching on the radio, pressing assigned button to the
backlight feature, or charging.
• Disabled – backlight is disabled and the display is always dimmed.
• On – backlight is always on.
Note: Setting the backlight intensity level by pressing the BACKLIGHT key changes the LED, keypad
backlight, and EMERGENCY button backlight intensity.
Setting Wallpaper
When and where to use: To change the look of the home screen.
Procedure:
1 From the home screen, press the MENU key.
2 Select Setup → Display → Wallpaper.
3 Select one of the following:
• On — To activate this feature.
• Off — To deactivate this feature.
Setting Contrast
When and where to use: This feature sets the contract of the display to enhanced visibility of the interface.
Procedure:
1 From the home screen, press the MENU key.
2 Select Setup → Display → Contrast.
3 Use left and right NAVIGATION key to change the value.
4 Press Ok.
Time and Date
This sub-menu controls the displayed time and date on the home screen.
Note: If the Home Display Text Message feature is enabled, Home Mode Display Text may cover time and
date, depending on the Configurable Idle Screen settings.
Note: Infrastructure synchronizes the time and date. When not within the infrastructure signal range you
can set the values manually.
Main Menu | 85
| | Send Feedback
To Next Page
Loading...
