7 Web Page Reference
110
Lowest Telecoms Modulation Mode
The lowest modulation mode at which telecoms data will be sent, if there is sufficient link
capacity.
In conjunction with the LINKPlanner tool, this setting may be used to optimize the latency for
links which operate in consistently high modulation modes. High data rate links are able to
support lower latencies.
The lowest telecoms modulation mode is selected from a rate ordered drop-down list. If this
selected mode has insufficient capacity to support the telecoms data then the effective lowest
modulation mode, determined when the wireless link starts, will be higher. The effective
lowest modulation mode is displayed on the Telecoms Configuration page.
To Next Page
Loading...
