7 Web Page Reference
141
7.10.5 Diagnostics Alarms
A number of diagnostics alarms have been added to allow SNMP agents to receive traps and
emails if required. Refer to Section 0 “
Hom
e Page Alarm Display” for a description of all these alarms. Checking the control
“Enabled Diagnostic Alarms” in SNMP and/or SNTP selects all the alarms shown in Figure
81. Users ca
n access the sub-menu “Diagnostic Alarms” to modify the alarms selected.
Figure 81 - Remote Management - Diagnostic Alarms
For a copy of the Motorola proprietary version 1 and version 2 MIB RFCs please consult the
installation CD
7.10.6 SNMP Configuration
The following SNMP configuration fields are displayed:
SNMP State
The SNMP state attribute controls the creation of the SNMP features. Changing the SNMP
state attribute requires a mandatory reboot of the unit. Only when the SNMP state is enabled
at system start-up will the SNMP processor task be created.
To Next Page
Loading...
