Motorola PTP 500 Series - Regulatory Issues with Connectorized Units

8 Recovery Mode
156
Figure 98 - Reboot Confirmation Pop Up
The unit will now reboot. The unit should now start up in normal mode but with the IP address
set to 169.254.1.1 and the Ethernet interface set to auto-negotiate and auto-MDI/MDIX.
Should the unit fail to start up the user should refer to Section 9 “ (Fault Finding”.
8.4 Erase Configuration
To erase the unit’s configuration the user should press the “Erase Configuration” button on
the “Recovery Options” page (Figure 92). The user will now be presented with a pop up box
asking the
m to confirm the action (Figure 99).
Figure 99 -
Confirm Erase Configuration Pop Up