Motorola PTP 500 Series - Remote Leds and Recovery Switch; Cables and Connectors; Figure 9

To Next Page

To Previous Page

2 Product Description

2.9 Remote LEDs and Recovery Switch

The PIDU Plus provides a facility to connect remote LEDs and Recovery switch allowing the

PIDU Plus to be mounted inside an enclosure. At the left hand end of the PIDU Plus under

the ODU connection cover can be found a PCB header and three jumpers. Jumpers J906 and

J907 should be removed and connection to the remote LEDs and Recovery switch made to

J908 as shown in Figure 9.

Figure 9 - Re

mote LED and Recovery Switch Wiring

2.10 Cables and Connectors

The cable used to connect the PIDU Plus to the ODU can be any standard CAT5e type

provided that it is UV resistant and suitable for outdoor deployment. Motorola recommends

that cables to the specification below be used:

Cable: Superior Essex BBDGE CAT 5e

Connector Type: Tyco, 5-569278

Gland: Motorola WB1811

CAUTION

Failure to use the recommended (or equivalent) standard of cable may invalidate the

system’s safety certification.

Motorola PTP 500 Series - Remote Leds and Recovery Switch; Cables and Connectors; Figure 9 - Remote LED and Recovery Switch Wiring