Motorola PTP 500 Series - Reset IP & Ethernet Configuration; Figure 96 - Confirm Reset to Factory Default Pop up; Figure 97 - IP and Ethernet Erased Successfully Page

8 Recovery Mode
155
8.3 Reset IP & Ethernet Configuration
To reset IP & Ethernet configuration back to factory defaults the user should press the “Reset
IP & Ethernet Configuration back to factory defaults” button on the “Recovery Options” page
(
1Figure 92). The user will now be presented with a pop up box asking them to confirm the
action (Figure 96).
Figure 96 -
Confirm Reset to Factory Default Pop Up
On confirmation the following page will be displayed (Figure 97). The user should now reboot
the unit by pressing the
“Reboot” button.
Figure 97 - IP and Ethernet Erased Successfully page
The user will now be presented with a pop up box asking them to confirm the action (Figure
98).