Using Pre-Event and Record After the Fact® (RATF)
Pre-Event Capture
Pre-Event supported values are none, 15 secs, 30 secs, 1 min, and 2 mins. You can configure
Pre-Event to include audio. You can have audio for the event but not for Pre-Event. The evidence
is always written to storage.
As shown in the graphic, you start a recorded event at 2:15 PM and stop it at 2:35 PM. With a Pre-
Event Capture time configured for one minute, the recorded event includes video recorded from
2:14 PM to 2:35 PM.
Note: Pre-Event only works if your camera is continuously recording.
1 Shift begins. Camera on and recording
2 Record button pushed to start
3 Record button pushed to stop
4 2:14 PM PreEvent time added = 1 minute (Agency determined)
Audio
Audio is NOT included with pre-event video unless your agency enables Force Microphone On
(page 43). Typically, the V300 only begins to record audio when you start a recorded event.
42
V300 Body-Worn Camera User Guide
WGD00169 Revision C
To Next Page
Loading...
