About the Features of the V300 Camera
LEDs for WiFi base
Two LEDs on the front of the WiFi base show power connection status. The LEDs are light-
sensitive and adjust to the ambient light.
Left LED
LED State WiFi base state
No light Powered off
Red Solid Charge error
Red Blinking Error condition
Pairing not successful
Red Blinking Error condition
Green Solid Fully charged
Green Blinking In shutdown or wireless upload timeout period
The left LED on the WiFi base blinks green when it successfully pairs with a V300. The LED
blinks red if the pairing was not successful.
Note: If you get a solid red light, try undocking and redocking your camera and
battery. If solid red appears repeatably, contact Customer Service.
Right LED
LED state State WiFi base state
Off Connected to Distributed Multi-Peer Recording
upload server (EL)
Amber Solid Not connected to camera or upload server
Amber Blinking Activity with upload server (EL)
Green Solid Connected to camera (Wi-Fi connection)
Green Blinking Activity with camera (Wi-Fi connection)
If two cameras are paired with the same WiFi base, and one is docked, the WiFi base LEDs show
the state of the docked camera.
64
V300 Body-Worn Camera User Guide
WGD00169 Revision C
To Next Page
Loading...
