About the Features of the V300 Camera
l Storage status
As the camera storage fills with recorded events, the Storage Used meter fills with bars and the
Storage Percentage increases.
l Upload status, if docked in the Transfer Station II or the WiFi base
The upload status shows the number of events uploaded out of the total number of events to
upload. Critical events upload first.
l Wi-Fi or GPS signal status
The Wi-Fi Signal Strength icon shows the status of the V300 Wi-Fi connection with the WiFi
base.
Display in different modes
l When the camera is not recording, the default message shown on the display is the number of
recorded events in storage.
l When the camera is in Covert Mode and not recording, the default message shown on the display
is Covert Mode
l When the camera is recording, the default shown on the display is the recording length.
Feedback Indicators
Apart from the displays, the V300 Camera can provide feedback on the status using:
l Tones
l Vibration
l Red and green LEDs
All of these feedback indicators are configurable in Evidence Library. You can set up the tones and
vibration to alert with:
l Tone only
l Vibration only
l Tone and vibration together
l No tone or vibration
You can configure the brightness level of the LEDs or set them to adjust automatically depending
on the time of day. They are dimmed from 8 pm to 8 am if you choose this option.
Note: If you place the camera in Covert Mode, no tones sound and the LEDs do not
light.
56
V300 Body-Worn Camera User Guide
WGD00169 Revision C
To Next Page
Loading...
