WiFi base
The fix status, longitude, latitude, speed, and time of day information is sent to the Metadata
service each second so that it can be included in the event data. The speed information is
compared to the configured maximum speed to determine if the vehicle has exceeded the
excessive speed trigger. If it has, a message is sent to the Event service to determine if an event
should be started.
Note: The GPS feature can be disabled in your EL configuration.
WiFi base
The Motorola Solutions V300 includes built-in Wi-Fi (802.11n).
You can dock the V300 Camera and battery or just the stand-alone battery in the WiFi base. The
camera pairs with the base to:
l Associate with a local recording group
The WiFi base acts as the Wi-Fi access point
(802.11n) for the V300 Camera to connect to
the local recording group network. The
broadcast range for the WiFi base depends on
its current environment. The WiFi base
typically associates with two cameras at one
time, but can associate with up to eight
cameras.
l Upgrading the Wi-Fi base is similar to
upgrading the V300 Camera . The V300
retrieves the WiFi base upgrade file just as it
retrieves the upgrade file for the camera.
l Update firmware
l Upload recorded events from storage (with an
Evidence Library connection)
l Charge the camera battery
For example, you can have a second battery charging in the base while your first battery is on the
camera.
Note: Charging in a vehicle base can be slower in warmer temperatures and can
impact the vehicle battery.
Important! Battery charging can shut down at ambient temperatures greater than
40° C / 104° F.
V300 Body-Worn Camera User Guide
WGD00169 Revision C
63
To Next Page
Loading...
