30 January 08, 2002 6881039B25
Disassembly
3. Using the flat end of the disassembly tool lift the display module from the
transceiver board as shown in Figure 16.
4. To replace, insert the end of the display module flex into the connector on the
transceiver board and press until the flex is fully seated in the connector.
5. Line up the display module mounting tabs with the corresponding notches in
the transceiver board, then press together until the display module snaps into
place.
011106-o
Figure 16. Removing the display module
DISPLAY MODULE
MOUNTING TAB
DISASSEMBLY TOOL
DISPLAY MODULE
TRANSCEIVER BOARD
TRANSCEIVER BOARD
FLEX CONNECTOR
DISASSEMBLY TOOL
To Next Page
Loading...
