8 Settings via the MICT
Rev. 08/2018 45
Symbol Menu Function
Device -> Reference Run
Initiates a reference run in manual mode (Service and
Advanced Service only).
Device -> Temperature
Extremes
Opens a window in which the maximum and minimum
temperature are displayed. These values are measured
throughout the operating time on the board of the
stepper motor driver.
Device -> Error
Acknowledge
All operating errors are acknowledged.
Device -> Trigger Error
The process carried out by the stepper motor driver
(e.g. a reference run), is canceled and the stepper
motor driver switches into error mode.
Device -> Access Control
The setup for the access control to the device is
described in a separate section. Please read the
section Access Control of the Stepper Motor Driver on
page 47.
Settings -> Language
Opens the window Select Language in which you can
change the interface language of the MICT.
Settings -> Online update
settings
Opens the window Online Update Settings. Refer to the
section Online Update Settings on page 46.
Settings-> Database
settings
Opens a dialogue window in various databases can be
assigned as source for the MICT.
Settings -> Temperature
scale
Opens the window Select Temperature Scale, in which
you can change the unit for the temperatures shown in
the MICT.
Settings -> Display by
cylinders
This function is available for certain MOTORTECH
ignition controllers and has no effect in conjunction
with the VariStep3.
Document
Has no function with the VariStep3.
Tools -> Coils
Opens a database with information on MOTORTECH
ignition coils.
Help -> Help
Opens the online help function.
Help -> About MICT
Opens detailed information on the MICT.
To Next Page
Loading...