Movacolor MCTC - Page 2

2
MCTC manual
Index
1 Introduction 4
Symbols 4
Terms 4
Transport 4
Receipt 4
Disclaimer 4
2 General information 5
Safety 5
Certification 5
Operating environmental conditions 5
3 General operation 6
The Interface 6
3.1.1 MCTC Touchscreen 6
3.1.2 MC-BC Blind controller 7
Start-up & Login 8
3.2.1 Configuration wizard 8
3.2.2 Home screen 8
3.2.3 Help function 9
3.2.4 User levels 9
System Configuration 10
The MCTC production screen 16
3.4.1 Injection Molding mode 16
3.4.2 Extrusion mode 17
3.4.1 Batch Mode 18
System performance 19
3.5.1 General 19
3.5.2 MCBalance, MCPowder, MCHigh Output and MCLiquid 19
3.5.3 MCHybrid 20
Quick start configuration after system reset 21
Material files 22
Recipe function 23
3.8.1 Material functions 23
3.8.2 Calculations 23
3.8.3 Calculation examples 24
3.8.4 Recipe editor screen 25
3.8.5 Creating a new recipe 26
3.8.6 Load / edit a recipe 26
3.8.7 Deleting a recipe 27
Tools Menu -NEW- 28
3.9.1 Fill System 28
3.9.2 Prime 28
3.9.3 Purge 28
3.9.4 One Shot 28
Purge function -NEW- 28
3.10.1 Configure the purge functionality 29
3.10.2 Setting the required purging RPM 30
3.10.3 Adjusting the purge motor speed 30
3.10.4 Purge recipe function 30
3.10.5 Using the purge function 31
Customer Support -NEW- 32
USB menu 33
3.12.1 Export and Backup / Restore 33
3.12.2 MCSmart USB logging 33
3.12.3 Remove USB stick 34
3.12.4 Insert USB memory stick 34
Consumption counters 35
3.13.1 Consumption counter by order 35