Movacolor MCTC - Page 3

3
MCTC manual
Consumption report 36
4 Events 37
General 37
Configuration 37
Active events 38
Operator events 38
Alarm history 38
Events 38
4.6.1 System events 38
4.6.2 Group events 38
4.6.3 Unit events 39
4.6.4 Component events 39
5 System 40
Main Material Sensor 40
5.1.1 Alarm settings 40
5.1.2 Electrical connections 40
6 Batch mode 41
Batch mode component configuration 41
6.1.1 Batch Settings 42
6.1.2 Batch unloading 42
Batch mode production screen 43
Connection examples batch unloading 44
6.3.1 Example 1 – Batch with unloading controlled manually 44
6.3.2 Example 2 – Batch with unloading controlled by MCTC 44
6.3.3 Example 3 – Batch with unloading option activated by pushbutton 45
7 MCTwin 46
Introduction 46
Closed loop 47
7.2.1 Configuration 48
7.2.2 Production 50
Open Loop 52
7.3.1 Production 53
8 Multi component 55
MCTC multi component controller 55
Group structure 56
MCBC blind controller 57
CAN bus connection 58
Alarm/warning output 58
Unit controller addressing 59
MCTC remote setup 60
Multi component production 61
8.8.1 Injection molding - gravimetric mode 61
8.8.2 Extrusion - gravimetric mode - tacho 62
8.8.3 Extrusion - gravimetric mode - relay 63
9 Outputs 64
MCBalance, MCPowder, MCHigh Output, MCLiquid 64
MCHybrid 65
10 Trouble shooting 66
APPENDIX A: MCTC Technical Specifications 67
APPENDIX B: MCTC Dimensional drawing 68
APPENDIX C: Standard electrical connections 69
APPENDIX D: Declaration of conformity 70