17
2. Turn crown clockwise until correct date appears
in window D.
3. Push crown back in to position 1 and screw back
down into case.
NOTE: If date is adjusted between 9:00 PM
and 12:00 AM when automatic date changes
are already in progress, it should be set to the
following day: The date will not automatically
advance at midnight if it has been corrected via
quick mode during these hours.
To set date/time following a battery change:
1. Pull unlocked screw-down crown out to position 2;
watch continues to run.
2. Turn crown clockwise until yesterday’s date
appears in window D.
3. Pull crown out to position 3; watch stops.
4. Turn crown clockwise until today’s date appears
in window D.
5. Continue to turn crown clockwise until hands
indicate correct time.
NOTE: Be sure to take AM/PM into account when
setting time.
6. Push crown back in to position 1, and screw back
down into case.
CHRONOGRAPH FUNCTIONS
Overview
Use buttons A and B to operate the chronograph.
Pressing button A the first time will start the
chronograph. Pressing button A a second time will
stop the chronograph, allowing elapsed time to
be read. Pressing button A a third time will restart
the chronograph. Pressing button B will reset
chronograph hands C, E and F to zero. Adjusting
the time does not stop the chronograph, but it does
block buttons A and B for as long as the crown is
pulled out.
NOTE: Crown must be in position 1 and hands must
be at zero before chronograph is started. Press
button B to reset hands to zero.
IMPORTANT: Do not push button A or B when
crown is pulled out to position 2 or 3. If button A or
B is accidentally activated while crown is not flush
against case, one or more of the chronograph
hands may become de-synchronized. Should this
occur, follow instructions at end for synchronizing
chronograph hands.
Simple chronograph functions:
To measure the duration of a single, non-stop
event:
1. Press button A to start chronograph.
2. Press button A a second time to stop
chronograph, and read the 3 chronograph
hands to determine elapsed time, for example: 1
hour, 8 minutes,
47 seconds.
3. Press button B to reset chronograph hands
to zero.
Accumulated time functions:
To measure the combined time of a series of
shorter events, for example the actual playing
time of a football game, where play is repeatedly
interrupted:
1. Press button A to start chronograph.
2. Press button A a second time to stop
chronograph and read elapsed time, for
example: 15 minutes, 22 seconds.
3. Press button A again to resume measurement.
4. Press button A a fourth time to stop chronograph
again, and read new elapsed time, for example:
28 minutes, 35 seconds.
NOTE: Each time you stop chronograph,
chronograph hands will indicate total accumulated
time.
5. Repeat steps 1 and 2 to add each additional
interval of time.
6. After you have taken your final accumulated
7
QUARTZ CHRONOGRAPH
1/1 OF A SECOND – TYPE A
Includes Series 800 Quartz chronograph & Movado BOLD TR90 chronographs
To Next Page
Loading...
