22
does not stop the chronograph, but it does block
buttons A and B for as long as the crown is pulled
out.
IMPORTANT: Crown must be in position 1 and
hands must be at zero before chronograph is
started. Press button B to reset hands to zero. DO
NOT push button A or B while crown is pulled
to position 2 or 3. If button A or B is accidentally
activated while crown is not flush against case, one
or more of the chronograph hands will become de-
synchronized. Should this occur, follow instructions
below.
Synchronization of chronograph hands:
After changing the battery, or in the event of an
error, the chronograph hands can be realigned
to zero if needed. A single push (quick press and
release) will advance hands by one increment. To
advance hands rapidly, depress and hold push
buttons for longer than one second.
Crown position 2:
Adjust minute-counter hand E using button B.
Crown position 3:
Adjust chronograph seconds hand C using button
A. Adjust tenths-of-a-second hand G using button
B.
OPERATING THE CHRONOGRAPH
Simple chronograph functions:
1. Press button A to start chronograph.
2. Press button A a second time to stop
chronograph.
3. Press button B to reset chronograph to zero.
Accumulated time functions:
1. Press button A to start chronograph.
2. Press button A a second time to stop
chronograph.
3. Press button A again to resume measurement.
4. Press button A a fourth time to stop chronograph
again.
NOTE: Each time you stop chronograph,
chronograph hands will indicate total accumulated
time.
5. Repeat steps 1 and 2 to add each additional
interval of time.
6. After you have taken your final accumulated
time reading, press button B to reset
chronograph hands to zero.
Split-time or intermediate time functions:
You can take intermediate time readings as a race
progresses with these models:
1. Press button A to start chronograph.
2. Press button B to momentarily stop chronograph.
3. Read off the intermediate time, for example: 10
minutes, 26 seconds, 3/10 of a second.
4. Press button B to resume chronograph function.
Hands will catch up with ongoing event.
5. To read a second split time, press button B again.
Repeat steps 2 through 4 to take any additional
split times.
6. Press button A to stop chronograph.
7. Take a reading of the final time, for example:
27 minutes, 3 seconds, 7/10 seconds.
8. Press button B to reset chronograph hands to
zero.
First place and runner-up results:
These chronograph models also allow you to
measure both a winning time and runner-up
results:
1. Start chronograph by pressing button A.
2. As soon as winner crosses finish line, press
button B. Chronograph will stop.
3. When second runner crosses finish line, press
button A.
4. Note time for the winner as shown on the dial.
5. Press button B; hands will move up to indicate
time for the runner-up.
6. Press button B again to return all hands to zero.
9
QUARTZ CHRONOGRAPH
1/10 OF A SECOND – TYPE B
Select Vizio Quartz chronographs
To Next Page
Loading...
