24
2. Turn crown clockwise until correct date appears
in big date window D.
3. Push crown back in to position 1.
NOTES: If date is adjusted between 9:00 PM
and 12:00 AM when automatic date changes
are already in progress, it should be set to the
following day: The date will not automatically
advance at midnight if it has been corrected via
quick mode during these hours.
If crown is turned too rapidly during quick mode
date setting, the date may not change properly at
midnight. To correct the date manually, pull crown
out to position 2, turn it clockwise until correct date
appears in window; then return it to position 1.
Setting date/time following a battery change:
For models without date, follow
To set the time
instructions above.
For models with Big Date feature at 12 o’clock (
see
Figure A
):
1. Pull crown out to position 2; watch continues to
run.
2. Turn crown clockwise until yesterday’s date
appears in window D.
3. Pull crown out to position 3; watch stops.
4. Turn crown clockwise until today’s date appears
in window D.
5. Continue to turn crown clockwise until hands
indicate correct time.
NOTE: Be sure to take AM/PM into account when
setting time.
6. Push crown back in to position 1.
CHRONOGRAPH FUNCTIONS
Overview
Use buttons A and B to operate the chronograph.
Pressing button A the first time will start the
chronograph. Pressing button A a second time will
stop the chronograph, allowing elapsed time to
be read. Pressing button A a third time will restart
the chronograph. Pressing button B will reset
chronograph hands C, E and F to zero. Adjusting
the time does not stop the chronograph, but it does
block buttons A and B for as long as the crown is
pulled out.
NOTE: Crown must be in position 1 and hands must
be at zero before chronograph is started. Press
button B to reset hands to zero.
IMPORTANT: Do not push button A or B when
crown is pulled out to position 2 or 3. If button A or
B is accidentally activated while crown is not flush
against case, one or more of the chronograph
hands may become de-synchronized. Should this
occur, follow instructions at end for synchronizing
chronograph hands.
Simple chronograph functions:
To measure the duration of a single, non-stop
event:
1. Press button A to start chronograph.
2. Press button A a second time to stop
chronograph, and read the 3 chronograph
hands to determine elapsed time, for example:
4 minutes, 38 seconds, 7/10-of-a-second.
3. Press button B to reset chronograph hands to
zero.
Accumulated time functions:
To measure the combined time of a series of
shorter events, for example the actual playing
time of a football game, where play is repeatedly
interrupted:
1. Press button A to start chronograph.
2. Press button A a second time to stop
chronograph and read elapsed time, for
example: 15 minutes, 5 seconds.
3. Press button A again to resume measurement.
4. Press button A a fourth time to stop chronograph
again, and read new elapsed time, for example:
28 minutes, 10 seconds.
10
QUARTZ CHRONOGRAPH
1/10 OF A SECOND – TYPE C
Includes Movado Heritage Series Circa, Museum Sport
To Next Page
Loading...
