Moxa Technologies NPort 6650 User Manual

NPort 6000 Series Log, Monitoring and Warning
11-7
UDP statistics
Received:
Received UDP datagram packets.
ErrPorts:
Received UDP datagram packets with invalid destination port.
ErrHeader:
Received UDP datagram packet with incorrect header.
Sent:
Sent UDP datagram packets.
TCP statistics
Received:
Total received packets of segments, including error packets.
ErrHeader:
Error packets (e.g., bad TCP checksums).
CurrEstab:
The counter of TCP connections for which the current status is either
ESTABLISHED or CLOSE-WAIT.
ErrPorts:
Received TCP datagram packets with invalid destination port.
Opens:
TCP connections.
Sent:
Total sent packets, including those on current connections.
ReSent:
Retransmitted packets.
Network Module
Check the information and status of the Network Module inserted in the NPort 6000.
Auto Refresh:
Default (Enable): Auto refresh the status every five seconds.
Redundancy Protocol:
Shows which communication protocol is in use: Turbo Ring, Turbo Ring V2, RSTP, or none.
Status:
Shows Healthy if the ring is operating normally, and shows Break if the ring’s backup link is active.
Master Slave:
Indicates whether or not this NPort 6000 is the master of the Turbo Ring. (This field appears only when Turbo
Ring or Turbo Ring V2 modes are active.)
ATTENTION
The user does not need to set the master to use Turbo Ring. If no master is
set, the Turbo Ring protocol will
assign master status to one of the EDS units in the ring. The master is only used to determine which segment
serves as the backup path.
1st Redundant Port Status (Port 1)
2nd Redundant Port Status (Port 2)
The “Ports Status” indicators show Forwarding for normal transmission, Blocking if this port is connected to
a backup path and the path is blocked, and Link down if there is no connection.

Moxa Technologies NPort 6650 Specifications

General

Brand	Moxa Technologies
Model	NPort 6650
Category	Server
Language	English