NPort 6000 Series Administration Settings
Access Permission
Administrators are allowed to enter the Access Permission section to customize User Group(s) and its
corresponding Function Group(s).
The User Groups in NPort 6000 are designed to provide administrators to manage user accounts in groups by
defining their access levels. You’re allowed to create at most four User Groups and assign up to four accounts
per User Group. By default, NPort 6000 is set with three User Groups: administrator, guest and port_admin.
Within these three User Groups, administrator and guest are not able to be deleted nor be modified.
The Function Groups in NPort 6000 are defined into six sets of functions, including:
Network Configuration
Settings in this function group are network related,
for example: setting up IP addresses, route table,
etc.
Serial Port Configuration
Settings in this function group are serial port
operation related such as serial parameters,
operation modes, etc.
System Configuration
Settings in this function group are device system
related, for example: device ser
upgrade, etc.
Administration
Settings in this function group are access control
related, for example: account management,
console settings, etc.
Log, Monitoring and Warning
Settings in this function group are
device/communication status
system log, system monitoring, email alert, etc.
Common Setting
Miscellaneous functions
You may click Add to create User Group and authorize access level of each function group described above to
this particular User Group. There are three access levels an Administrator can assign to a User Group: No
Display, Read Only and Read Write.
To Next Page
Loading...
Need help?
General
