RT-14 Quick Start Guide
11
Make a note of the RT-14’s IP address that is displayed in the
pop-up; for example 192.168.1.234.
9. You can use Flair to change the IP address stored in the RT-14, or to
inspect or change the SN or GW addresses. To do this:
9.1 Enter the RT-14’s existing IP address (as shown in the
Information pop-up) into the Network Setup window and click
on Save.
9.2 Click on Load to reset and load the RT-14.
Once Flair is connected to the head, any LAN address changes
that you make and Save in the Network Setup window will also
affect the LAN addresses stored in the head.
9.3 To change the IP address of the RT-14, enter the new IP
address into the Network Setup window now and click on
Save.
The Status temporarily changes to Not connected as Flair
changes the IP address in the RT-14, then to Connected as
Flair reconnects with the RT-14 at its new IP address.
9.4 To inspect or change the SN or GW address of the RT-14, click
on Find again. A pop-up shows the head’s three current LAN
addresses, and the Subnet Mask (SN) and Default Gateway
(GW) fields in the Network Setup window become editable.
Enter the new SN and GW addresses that you want to use and
click on Save.
10. Close the Network Setup window by clicking on Exit.
To Next Page
Loading...