MSA TransAire - Reassembling the Escape Hood

15 US
6 Maintaining the Escape Hood
a. AttachtheshoulderstraptothetopD-rings.

b. RemovethecarrierstrapfromtheD-ringandadjustthestraptoitsfull
length.
c. Dontheshoulderstrap.Pulltheadjustingstrapforasnug,comfortablefit.
d. AttachthecarrierstraphooktotheD-ringandadjustthestraptoyour
waistsize.
6.4 Reassembling the Escape Hood
1. ChecktobesurethereisanO-ringintheregulatorinlet.Threadthepressure
regulatorontothecylindervalveandtightenwithasuitablewrench.

2. Placeafullaircylinderinthecarrierandtietheopeningclosedaroundthe
cylinderneck.
3. ChecktobesurethatthereisanO-ringonthehoodhosenipple.