MSG Equipment MS002 COM - Disposal

English
User manual
25
11. During the belt
(chain) tightening there
are abnormal noises or
irregularity of operation
The belt tightening motor is
worn out
Replace the motor
The belt tightening sprocket is
worn out
Contact technical support
The belt tightening screw is
worn out
There’s no lubricant on the
sliding surfaces
Grease the sliding surfaces
The working parts are very dirty
Clean the working parts
12. When pressing the
tightening control
button nothing happens
The tightening control module
failed
Contact technical support
The control board failed
D-SUB connector of the motor
supply is disconnected
Fix D-SUB connector
There’s no contact at the
supply connectors of the
tightening electric motors
Recover contact of the electric
motor supply
9. DISPOSAL
Equipment deemed unfit for use must be disposed of.
The equipment does not contain any chemical, biological, or radioactive elements that could
harm human health or the environment when proper storage and usage rules are followed.
Disposal of the equipment must comply with local, regional, and national laws and regulations.
Do not dispose of non-biodegradable materials (PVC, rubber, synthetic resins, petroleum
products, synthetic oils, etc.) in the environment. For the disposal of such materials, contact
companies specializing in the collection and disposal of industrial waste.
Copper and aluminum parts, considered non-ferrous metal waste, should be collected and sold.