Promise FastTrak 579 Parallel ATA / Serial ATA RAID Introduction
5-19
Under the Security setting in Auto Setup, FastTrak assigns two drives for a single
Mirrored array.
Choose this method if you wish to use a drive that already contains data and/or is the
bootable drive from your system. Obtain a second disk drive of equal or larger storage
capacity.
To create an array for data protection using an existing data drive, follow these steps:
1. Press the Spacebar to choose Security in the Optimize Array field.
2. Press Ctrl-Y to Save your selection. The window below will appear.
3. Press Y for the Create and Duplicate option. The window below will appear asking
you to select the Source drive to use. FastBuild will copy all data from the Source
drive to the Target drive.
To Next Page
Loading...
Need help?
General
