Promise FastTrak 579 Parallel ATA / Serial ATA RAID Introduction
5-33
Array Critical
When a disk drive fails on a fault-tolerant array (RAID 1 and 0+1) for any reason,
the Array goes Critical. The array can still read and write data but fault tolerance
has been lost.
An Array Critical icon displays in Tree View and the alarm (if enabled) beeps
quickly to call your attention to the condition.
Your first action is to identify which disk drive has failed.
1. Click on the Controller icon to expand it.
2. Click on the Array icon to expand it.
3. Observe and compare the disk drives currently displayed with those
originally assigned to the Array.
In the example above, there are two disk drives attached to the FastTrak
Controller and both are assigned to a RAID 1 array.
The disk drive on Channel 2 does not appear. This is the failed drive.
• If you have a Hot Spare drive installed and enabled, the array will begin to
Rebuild automatically.
• If you do not have a Hot Spare drive, you must replace the failed drive before
a Rebuild of the array can begin
To Next Page
Loading...
