AWARD
®
BIOS Setup
3-23
VGA
When ON, you can set the VGA to awaken the system.
LPT & COM I/O Access
The settings are NONE, LPT, COM and COM/LPT. You can set which port
is used to wake up the system when there is any activity detected from one
of the listed ports.
HDD & FDD I/O Access
When HDD & FDD is On, any activity detected from one of the listed
system peripheral devices or IRQs wakes up the system
PCI Master
When PCI Master is On, any activity from the listed system peripheral
devices or IRQs wakes up the system.
VGA Off
LPT & COM I/O ACCESS LPT/COM
HDD & FDD I/O ACCESS On
PCI Master Off
Power On by PCI Card Disabled
Wake Up On LAN/Ring Disabled
RTC Alarm Resume Disabled
Date (of Month) 0
Resume Time (hh:mm:ss) 0:0:0
IRQs Wake Up Event ON
IRQs Activity Monitoring Press Enter
Item Help
Menu Level >
↑ ↓ → ← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-safe defaults F7:Optimized Defaults
x
x
8
Blinking The Power LED blinks to indicate the suspend state.
Single The Power LED remains the same color.
Dual The Power LED changes its color to indicate the
suspend state.
Wake Up Events
To Next Page
Loading...
