Mueller SENTRY II - Pump Assembly Replacement Parts List

Sentry II with Water Works Box Operating Instructions Effective April 1, 2000
Part No. 8823728 Revised November 10, 2003
9.28 Label No. 30166, Caution - Vent Must Be Over Milk Inlet
9.29 Label No. 8802777, Caution - Do Not Sanitize
9.30 Label No. 8823146, Terminal Block - 24 VAC - 240 VAC
59
CAUTION
¡
CUIDADO!
VENT ASSEMBLY
MUST BE OVER
MILK INLET AT ALL
TIMES.
EL ENSAMBLAJE
DE VENTEO DEBE
ESTAR SOBRE LA
ENTRADA DE LA
LECHE EN TODO
MOMENTO.
30166
CAUTION
Do not sanitize your cooler
with solutions containing
in excess of 200 parts
per million of chlorine.
Do not mix sanitizers
or any chlorine containing
substances with acid as this
will result in damage to the
stainless steel surface
and can generate a gas
that is lethal to your health.
Do not exceed 170°F(76°C)
during the wash cycles.
8905 8802777
0003 8823146
1 2 3 4 5 6 12 13
1 2 3 4 5 6 7
8 9 10 11 12 13 14
TEMPERATURE CONTROLLER
(SENTRY II MODELS ONLY)
GROUND ONE END ONLY
AT SENTRY II CONTROL BOX
GRD
GRD
"OE" THERMOSTAT
(OE MODELS ONLY)
AGITATOR
(240 VAC)
PUMP MOTOR
(240 VAC)
AGITATOR
(240 VAC)
1
2
DRAIN VALVE
(24 VAC)
THERMOCOUPLE
(SENTRY MODELS ONLY)
CONSTANTAN ( )
COPPER (+)
USE NON METALLIC WIRE NUTS ONLY
CAP AND INSULATE DRAIN WIRE
AT MILK COOLER JUNCTION BOX
CONSTANTAN ( )
COPPER (+)
DRAIN WIRE
®
HIGH VOLTAGE TERMINAL CONNECTIONS:
1 - THERMOSTAT (OE MODELS ONLY)
2 - THERMOSTATE (OE MODELS ONLY)
3 - AGITATOR(S) L1 - 240 VAC
4 - AGITATOR(S) L2 - 240 VAC
5 - WASH PUMP MOTOR L1 - 240 VAC
6 - WASH PUMP MOTOR L2 - 240 VAC
LOW VOLTAGE TERMINAL CONNECTIONS:
12 - ELECTRIC DRAIN 24 VAC LINE
13 - ELECTRIC DRAIN 24 VAC COM.