160
Ultima S / SL Flex & Pro
3/2019
114060421
Hooklift Multilift Ultima S / SL Flex & Pro
Service Manual
Electric system
Maintenance and repair works in the electrical system may be carried out only by a trained
electrician.
All the safety instructions and regulations related to electric work must be noted.
Use always only original electric components.
It is not allowed to make any additional connections to the electric system, wiring harnesses
and valve coils.
Repairing Damaged Paint Surface
Ultima hooklift is painted with polyurethane paint in accordance with standard PUR 100/1
FeSa 2 ½. The frame of the device can optionally be coated with a zinc-primer before
surface coating, in accordance with standard EPZn®PUR 140/2 FeSa 2 ½.
Surface damage occurring during the transport, installation or usage of the device must
immediately be repaired to prevent the damage from spreading:
Cover up surfaces near the device, clean up the damaged area and surfaces surrounding
it of any impurities and existing paint down to the steel surface, even out the edges of
the paint surface. Make sure that the surface is completely free of dust, oil and grease
and that it is completely dry for repair painting. Apply a 100 μm coat of primer. It is not
recommended to use a primer for the surface coating. Use a pre-shaded acrylic paint for
the repair painting and conrm the colour shade and colour code (RAL) before applying
the paint. Let the paint dry for 24h indoors before use.
If auxiliary equipment is installed to the device afterwards, the surfaces in contact with the
painted area must be protected with suitable protective wax.
To Next Page
Loading...