Self-moving multipurpose loader MULTIONE
1 Series
MultiOne SRL
Instruction manual (Traslation of original instructions)
CM170001EN - 01.03.17 - 03 (11.07.18)
38/49
9.7 Interventions on the machine
9.7.1 Cleaning of the machine
The cleaning of the machine is essential to ensure reliability and efficiency. The accumulation of dust and dirt can cause malfunctions
and damages.
At the end of the workday, especially if the machine is being used in dusty conditions, proceed to clean:
• The outer surfaces of the machine can be washed with a pressure washer and a clean cloth.
• Clean the inside of the cabin with appropriate mild detergent and a clean cloth.
WARNING
IT IS FORBIDDEN TO USE HIGH PRESSURE WATER JETS.
9.7.2 Check tyres pressure
Inflate the tyres to the correct pressure ensures reliability and more safety when using the machine. Before inflating check the
integrity of the tyre and wheel, if they are damaged, replace them. The inflation pressure is indicated in par. 11.1.
DANGER
NEVER EXCEED THE VALUE OF INFLATION PRESSURE RECOMMENDED ACCORDING TO THE TYRE MODEL.
9.7.3 Check structural integrity and tightening bolts
• Safety belts: check the attachment points and relative bolts are intact and the coupling system is not damaged.
• Bolts wheels: check that the bolts are tightened.
9.7.4 Battery check
WARNING
THE BATTERY ACID IS HIGHLY POISONOUS AND CAN CAUSE BURNS AND IRRITATION. ALWAYS WEAR PERSONAL PROTECTIVE
ATTACHMENT (GLOVES, GOGGLES, PROTECTIVE SUIT).
The battery is located inside the engine compartment.
1) Put the machine in “safety state” (see par. 9.2).
2) Open the engine cover (see par. 9.4).
3) Checks:
• The battery (FIG. 20 - Ref. 1) is intact and not leaking.
• Check power cable connections for signs of leaking, corrosion, or damage.
• Check to make sure the battery is securely attached to the machine frame.
9- MAINTENANCE
To Next Page
Loading...
Need help?
General
