MultiOne 1 Series User Manual

Self-moving multipurpose loader MULTIONE
1 Series
MultiOne SRL
Instruction manual (Traslation of original instructions)
CM170001EN - 01.03.17 - 03 (11.07.18)
44/49
9.8 Engine maintenance
WARNING
SERVICE AND MAINTENANCE INSTRUCTIONS FOR THE ENGINE CAN BE FOUND IN THE ENGINE’S MANUAL SUPPLIED WITH THE
MACHINE.
9.8.1 Check engine oil level
The cap of the engine oil filler with dipstick is located both on the right and on the left side. It is advisable to check the oil level using
the cap on the right side.
To check the engine oil level proceed as follows:
1) Put the machine in “safety state” (see par. 9.2).
2) Wait until the engine has cooled down.
3) Remove the rear right panel.
4) Open the cap of the engine oil filler (FIG. 25 - Ref. 1)
5) Look for both the full and add oil lines of dipstick. The correct oil level is between those two lines.
6) If the refill is needed, add oil. It is important to add the correct type of engine oil as stated in the engine manual.
7) Make sure to reinstall and secure the oil filler cap.
8) After filling the oil, wait a few minutes and check the oil level again
FIG. 25
1
1
MAX
MIN
MAX
MIN
RIGHT SIDE
LEFT SIDE
9- MAINTENANCE

MultiOne 1 Series Specifications

General

Brand	MultiOne
Model	1 Series
Category	Compact Loader
Language	English