Muratec MFX-2570 - Setting Closed Reception

Closed Communication 2-11
1
2
Management
Press [Closed T
5
ransmission].
Select [ON] and press [Enter].
6
Press [OFF] to disable closed transmission.
Setting Closed Reception
If you set closed reception, since the sender that faxes can be received from is limited, you
can avoid receiving faxes from the wrong machine due to an entry error.
Note
To set the passcode, refer to “• Setting the Passcode”. (See page 2-14.)
For details on the communication range using closed communication and passcodes, •
refer to “Communication and Range of Passcodes”. (See page 2-15.)
Press <Setting>.
1
Press [Management].
2
If an administrator password is set, enter the password and press [Enter].
3
If an administrator password is not set, proceed to step 4.