2-44 Specifying the Network Settings
Item Description
IPv6 Setting You can set the following settings:
l
Obtain IPv6 address
l
Link Local Address
l
Global IP Address
l
Subnet Prefix Length
l
Default Gateway
For details on the IPv6 settings, refer to Chapter 3, “Setting the
Connection Environment” in the OfficeBridge Guide.
You can also specify TCP/IP settings using • OfficeBridge. For details, refer to Chapter
3, “Setting the Connection Environment” in the OfficeBridge Guide.
Make sure to obtain permission from the network administrator before changing •
the IP address. Improperly changing the IP address may cause the network to stop
functioning normally.
Opening the TCP/IP Settings Screen
Press <Setting>.
1
Press
2
the [Management] tab.
If an administrator password is set,
3
press [Admin Password].
If an administrator password is not set, proceed to step 5.
Enter the administrator password, and press [Enter].
4
Press [Network Settings].
5
Press [TCP/IP Settings].
6
Specify each setting.
7
To Next Page
Loading...
Need help?
General
