Muratec MFX-3550 - Media and Tray; Preparing Originals; Loading Originals

Media and tray
This chapter provides information on how to load originals and print media into your machine.
This chapter includes:
z
Preparing originals
z
Loading originals
z
Selecting print media
z
Changing the tray size
z
Loading paper in the tray
z
Printing on special media
z
Setting the paper size and type
z
selecting an output location
PREPARING ORIGINALS
z
Do not load paper smaller than 142 x 148 mm (5.6 x 5.8 inches) or larger than 216 x 356 mm (8.5
x 14 inches).
z
Do not attempt to load the following types of paper, in order to prevent paper jam, low print quality
and machine damage.
{
Carbon-paper or carbon-backed paper
{
Coated paper
{
Onion skin or thin paper
{
Wrinkled or creased paper
{
Curled or rolled paper
{
Torn paper
z
Remove all staples and paper clips before loading.
z
Make sure any glue, ink, or correction fluid on the paper is completely dry before loading.
z
Do not load originals that include different sizes or weights of paper.
z
Do not load booklets, pamphlets, transparencies, or documents with other unusual characteristics.
LOADING ORIGINALS
You can use the scanner glass or the automatic document feeder to load an original for copying,
scanning, and sending a fax.
On the scanner glass
Make sure that no originals are in the document feeder. If an original is detected in the document
feeder, the machine gives it priority over the original on the scanner glass. To get the best scan
quality, especially for colored or gray-scaled images, use the scanner glass.
1. Lift and open the scanner lid.
Pa
g
e 1 of 14Media and tra
y
8/4/2009htt
p
://downloadcenter.samsun
g
.com/content/UM/200907/20090721152022250/EN/en
g
lish
/
...
67