Holding of signal waveform
When collection of data is continuing, the waveform of signals will be constantly refreshed. When the data
collection is stopped, the display content will be held. The main purpose of holding waveform is to hold the current
data or waveform, so as to make close observation easier. The current wave also has to be held before it is stored into
database.
There are two methods for holding wavedata: Press “S” button or use single trigger scanning mode.
Press “S” button to start or stop the collection of waveform data. Once the collection of wavedata by the
scopemeter is ceased, the display is held.
To Next Page
Loading...
