Turning the power ON/6
OFF
This section explains how to turn the printer
ON/OFF.
Turning the power ON6.1
Follow the procedure below to turn the power
ON.
Press the [Power] key on Operation panel to
1.
turn ON the printer.
Power lamp on Operation panel lights up in ・
blue.
The printer starts the initial operation. ・
When the initial operation is complete, the ・
printer enters the Normal condition.
Turning the power OFF6.2
Follow the procedure below to turn the printer OFF.
Verify the following regarding the opera-
1.
tional condition of the printer.
Printing or other operations are not in prog-・
ress.
Operation panel display is Normal.・
Press the [Power] key on Operation panel to
2.
turn OFF the printer.
Power lamp on Operation panel turns OFF.・
If Operation panel is in the following status,
z
the power is ON.
The [Power] key is pressed in.
・
Power lamp is ON.
・
Press the key once again to turn the power
OFF.
The printer turns the power OFF.・
When the media is set, “Lift the lever” is dis-
z
played on Operation panel.Raise Media load-
ing lever.
“Wait for a while...” is displayed on Operation ・
panel.
All the lamps on Operation panel and the LCD ・
monitor are turned OFF.
The printer automatically turns the power OFF.・
After turning OFF the printer, wait for ten sec-
z
onds or longer to turn it ON again.
If you are not using the printer for a long
3.
time, raise Media loading lever.
Activating the printer7
This product requires activation when the power
is turned ON for the first time.
When “Activation required” is displayed on
Operation panel, follow the “Printer activation
guide”* and perform activation.
*Download the “Printer activation guide” from
the following ValueJet Club.
https://mbss.mutoh.co.jp/mutoh/guser/
No. Name
1 Media loading lever
To Next Page
Loading...
Need help?
General