VJ-1624 QUICK REFERENCE 4 Daily maintenance
4-29
3. Press the [>] key on the operation panel to select the cleaning mode.
4. Press the [Cleaning] key on the operation panel for at least two seconds.
• Start Head cleaning.
• "Cleaning **%" is displayed on the operation panel.
• After Head cleaning is complete, the operation panel shifts to Normal.
NOTE
• If you fail to remove blurs or incompleteness of printing in one Head cleaning, perform strong
cleaning.
• If blurs or lacking parts in printed media do not disappear with several times of Head cleaning,
refer to "5 Troubleshooting", and take appropriate measures.
4.2.4 Cleaning the cleaning wiper
This section describes the procedure to clean the cleaning wiper.
(1) Time for cleaning
Once a week, or when blurs or lacking parts appear on printed media after Head cleaning.
To Next Page
Loading...
Need help?
General