To Next Page

To Previous Page

5 Troubleshooting VJ-1624 QUICK REFERENCE

5-12

4. Check the both ends and the center of the print result that printed with Adjust pattern, and select the

number from 1 to 7 that is not out of alignment.

• "6" is selected in the next printing sample.

NOTE

• "4" is the current setting value.

5. "Pattern *: 4" (* indicates a pattern name as shown below) is displayed on the operation panel.

• The pattern name (*) differs depending on the set print mode.

The print modes and their pattern names are as follows.

6. Press the [+] key or [–] key to enter the number that you selected in Step 4.

PrintMode PatternName

Quality 1, 2 C

Quality 3, 4 B

Graphics 1, 2 E

Graphics 3, 4 D

Banner 1, 2 A

Banner 3, 4 A

MUTOH ValueJet VJ-1624 Quick Reference

Other manuals for MUTOH ValueJet VJ-1624