- 84 -
Maintenance
B
q Steering damper
- After some seconds, the display shows the available
modes for steering damper adjustment (“AUTO”:
automatic; “MANUAL”: customised).
- Press “OK” for less than three seconds; the “AUTO”
caption will start blinking.
- Press “SET” for less than three seconds; the
“MANUAL” caption will start blinking. Pressing “OK”
for more than three seconds enables you to modify
the steering damping value.
- Press “OK” for less than three seconds: the steering
damping level rises up to the next value. Such value
may range between 4 and 18.
- Press “OK” for over three seconds to confirm the
selected steering damping level; the display returns to
the suspension adjustment mode. Otherwise, press
“SET” for less than three seconds to stop the adjust-
ment procedure and confirm the selected suspension
adjustment values.
“ABS” Mode * (MY13)
- Press “SET” in order to access to “ABS” mode; “SET-
TING ABS” appears on the display.
WARNING
The display modes may be changed or set
when the engine is off, the gear in neutral,
the motorbike stationary with your feet on
the ground. Do not change the display while
driving.
(*): This function is present only on certain models
To Next Page
Loading...
