Suspension and wheels
F
- 37 -
Utilising the special tool, tighten the screw ring (1) to
the prescribed torque pressure.
Special tool No. 800092857
Torque pressure: 120 ÷ 125 N·m
During this tightening operation, press down with force
onto the head of the special tool.
1
120÷125 N•m
Assembly of the lower steering bearing
If it is necessary to replace the steering base comple-
te with pin, before assembling it on the bike you must
carry out the following preliminary operations.
Accurately clean all previously removed parts and
check the general condition.
Before reassembly, grease the internal ring of the bea-
ring and the ball bearing on the steering pin with the
prescribed grease.
Recommended grease: Agip Grease 30
Insert the anti-dust seal, the internal bearing ring and
the ball bearing ring on the new steering base.
Insert the bearing assembling tool (special tool) on the
steering pin.
Special tool No. 800097890
Place the steering base on the corresponding support
plate (special tool).
Special tool No. 800097888
By using a press, squeeze down the lower steering
bearing components on the steering pin.
Now it is possible to remove the bearing assembling
tools and proceed with the assembling of the steering
base on the bike.
To Next Page
Loading...
