- 36 -
Frame
G
- F4 R - F4 MY13:
Carefully clean the seats of the steering bearings.
Check that no surfaces have any bumps or dents.
Check that none of the area highlighted in the figure is
deformed (as a result of any accidents).
Check that there are no dents or evident breakage on
frame tubes.
Replace frame if any damage is detected.
In this case, remove the following components:
- Exhaust valve actuator / Fuse box / Support
- Injection control unit / Support
- Dashboard / Front headlight support
- Clamps / Electrical wiring
To Next Page
