EV-030 Rev. 07 – 2008
English
28
Installing the magnetic sensor for vertical shaft anchor
windlasses
(see Fig. 1A – 1B)
• Drill a 4 mm (~3/16”) hole in the cover through
which to thread the sensor cable.
• Fasten Part A of the support with the two
screws provided, after having positioned the O-
ring in the lower part of the support.
• Fit Part B with the magnetic sensor on support
A and adjust its height until it is aligned with the
magnet fastened on the gipsy.
• Bring the sensor to a distance of about 3 mm
(~1/8”) from the magnet and secure it in place
by tightening screw G1. Then tighten screw G2.
Installing the magnetic sensor for
horizontal shaft anchor windlasses
(see Fig. 2A – 2B – 2C)
• Drill a 4 mm (~3/16”) hole in the cover through which to
thread the sensor cable.
• Fasten Part A of the support with the two screws
provided, after having positioned the O-ring in the lower
part of the support.
• Cut Part C to measure using a hacksaw. The sensor
must be positioned at a distance of about 3 mm (~1/8”)
from the magnet.
• Fit Part C with the magnetic sensor on support A and fix it
in place using an adhesive for plastic (two-component
epoxy glue) or silicone.
• Using the same glue, attach the sensor to Part C.
C
A
OR
OR
A
B
G1
G2
To Next Page
Loading...
