MZ electronic EV-030 - Instrument calibration

EV-030 Rev. 07 – 2008
English
45
Instrument calibration
Before using the instrument the following parameters must be set:
• choice of unit of measurement (metres or feet);
• Setting of the Rope_Chain function (optional sensor type CMCT-01);
Measure
Reset Measure No
Units Feet
Rope_Chain Off
Exit
• detection of type of sensor (Standard or Project);
• gipsy diameter setting (default value 33 cm) or reduction factor (default
value 57);
Standard and X.. Project series
sensor menu
Sensor Calibrat
Barb. Circ. 33.0
Exit
1000 – 1500 –2000 W Project series
sensor menu
Sensor Calibrat
Red. Factor 57.0
Exit