EV-030 Rev. 07 – 2008
English
34
Once the initialisation procedure is complete, the main page will appear.
Where:
STATUS: indicates the status of the instrument and any failure.
SPEED’: indicates the chain speed during hoisting or lowering in meters per
minute or feet per minute.
COUNT: indicates the measurement of the chain lowered (in metres or feet).
MONITORING: indicates the power supply voltage.
ICONS: this is the part of the display bearing the icons that indicate the hoisting
or casting of the anchor and any failure.
When the instrument is turned on for the first time, it will set up as programmed
in the factory (see table).
Parameter Default value
Up Alarm 3.0 metres
Auto Down Off
BackLight Time 30 seconds
Units of measurement Metres/centimetres
Chain Measure 0.0 metres
Barbotin Circumference 33 cm
Sensor type unknown
Keyboard Beep Yes
Language Italian
Works Hours 0
Rope_Chain Off
To Next Page
Loading...
