6 DIMMER
• Reduce or restore VFD brightness.
• Depending on the NAD model, the brightness of the front panel display will vary when you
toggle this button.
• Use with NAD C 390DD and other compatible NAD Stereo Receiver, Tuner and CD Player
models.
7 TEST
Initiate speaker TEST mode while at the Speaker Levels section of the Speaker Setup menu. This is
not applicable to C 390DD.
8 MUTE
• Temporarily mutes audio output or restores audio from mute mode.
• MUTE mode is indicated by ashing Standby LED indicator for NAD Integrated Ampliers or
“Mute” shown in the VFD of NAD Receivers. For C 390DD, “MUTE” is shown in the VFD.
• Adjusting the volume level via the AVR 4 or the front panel volume knob will automatically
release the mute function.
9 SOURCE p/q
• Toggle through the input selections - Digital Coaxial 1, Digital Coaxial 2, Digital Optical 1, Digital
Optical 2, Digital AES/EBU, Computer, Digital USB Back and Digital USB Front. If the optional
modules like the DD HDMI 1 (Direct Digital HDMI) and the DD AP 1 (Direct Digital Analog/
Phono) modules are installed, the source selections will continue on with the corresponding
sources of said modules.
10 SURR
Select desired listening or surround mode. This is not applicable to C 390DD.
11 p VOL q
• Increase or decrease loudness level. Release the button when desired level is reached.
• The VFD on the front panel will indicate the level set. For NAD Receivers, the VFD will also show
“Volume Up” or “Volume Down” or “Volume: -/+_ _ dB” (-/+_ _ indicates the numerical dB level)
while pressing AVR 4’s [VOL p/q ] buttons. For C 390DD, “Vol: -/+ _ _._ dB” is shown in the VFD.
12 D/F/A/S, ENTER
Select an item in a menu.
13 SLEEP
Switch o the NAD Receiver or Tuner after a preset number of minutes. This is not applicable to
C 390DD.
14 EQ
Bring up the adjustable Equalization parameters Frequency, Level and EQ levels.
15 TONE
• Adjust Treble or Bass level.
• Toggle [TONE] button to select “Treble” or “Bass” and then use the [D/F] to adjust their
respective levels.
16 L.NITE
Set Dynamic Range Control (DRC) level. Toggle [L.NITE] to select either DTS or Dolby DRC setting
and then use [D/F] buttons to set up DRC level. This is not applicable to C 390DD.
IDENTIFICATION OF CONTROLS
AVR 4 REMOTE CONTROL
11
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ
To Next Page
Loading...
Need help?
General
Weight and Dimensions
