13
ENGLISH
FRANÇAISDEUTSCHNEDERLANDSESPAÑOL
ITALIANO
PORTUGUÊS
SVENSKA
8. ext. 7.1: Press to select the 7.1 CH AUDIO IN analog inputs. These inputs bypass the
M15's processor. Tone controls are not available with this input, only Volume control.
9. surround mode: Press and hold while simultaneously using the volume (set up) knob to
sequentially select the surround modes. Depending on the speaker setup, format, and
signal type some surround modes may not be made available.
The following are all the possible decoding and post processing options for 2-channel PCM
96kHz with THX option turned on or off. See figure A
The following are all the possible decoding and post processing options for analog inputs
and 2-channel PCM 44.1kHz, 2-channel PCM 48kHz, Dolby Digital 2.0 and DTS 2.0, with
THX option turned off. See figure B
Note: if the surround back speakers are set to "none" then Dolby PLIIx Movie and Music
will be replaced with PLII Movie and Music.
The following are all the possible decoding and post processing options for analog inputs
and 2-channel PCM 44.1kHz, 2-channel PCM 48kHz, Dolby Digital 2.0 and DTS 2.0, with
THX option turned on. See figure C
Note: if the surround back speakers are set to "none" then PLIIx + THX and PLIIx Music will
be replaced with PLII + THX and PLII Music.
The following are all the possible decoding and post processing options for Dolby digital
5.1 inputs with THX option turned off. See figure D
Notes: if the surround back speakers are set to "none" then Dolby Surround EX, Dolby
PLIIx Movie and Music will be skipped.
if the surround back speakers are set to “1 LARGE” or “1 SMALL” then Dolby Surround
EX and Dolby PLIIx will be available.
ABOUT THE M15
Identification of controls
To Next Page
Loading...
