Powering the HD PREAMP
The power cord of the HD PREAMP is connected on the rear panel of its power
supply chassis. The power supply chassis converts the Mains supply into several
different regulated voltages sent to the audio device chassis through two umbilical
cords with LEMO plugs. These umbilical cords are supplied with the HD PREAMP.
Connection to the Mains
Push the Mains appliance inlet switch at the back of the power supply chassis into the
(OFF) position. Insert the Mains cord into the IEC connector of the power supply chassis.
↑
↓
↑
↓
02
NAGRA HD PREAMP // INSTALLATION // 010 + 011
To Next Page
