National Instruments GPIB Series User Manual

Chapter 3 Ethernet Configuration
© National Instruments Corporation 3-9 GPIB-ENET/100 for Windows Me/98/95
• Keep the existing hostname. Use this option if you wish to keep
the previously assigned hostname. If you select this option,
contact your network administrator to change the DNS entry.
4. Review the network parameter settings in the Properties window.
5. Confirm that the device is in network configuration mode and click
OK. The device reboots with the new settings in effect.
6. After the device reboots, click Refresh to verify that the hostname is
now valid.

National Instruments GPIB Series Specifications

General

Bus Interface	GPIB (IEEE 488)
Operating Systems Supported	Windows, Linux, macOS
Weight	Varies by model
Form Factor	PCI, PCIe, USB
Number of GPIB Ports	1
Software Support	NI-488.2 driver
Compatibility	IEEE 488.1, IEEE 488.2
Connector Type	24-pin IEEE 488 connector
Power Requirements	Varies by model (e.g., USB bus-powered or external power)
Dimensions	Varies by model
Data Transfer Rate	Up to 8 MB/s