National Instruments GPIB Series - Page 7

Contents
GPIB-ENET/100 for Windows Me/98/95 viii ni.com
Chapter 4
GPIB Configuration
Configuring the NI-488.2 Software Characteristics...................................................... 4-1
Chapter 5
Verify the Installation
Power-On Self Tests...................................................................................................... 5-1
Run the NI-488.2 Getting Started Wizard..................................................................... 5-1
Connecting the GPIB Cable .......................................................................................... 5-3
Chapter 6
Using Your GPIB-ENET/100 and NI-488.2
NI-488.2 Getting Started Wizard .................................................................................. 6-1
Using DHCP.................................................................................................................. 6-2
Using the CFG RESET Switch...................................................................................... 6-3
Using the CFG RESET Switch during Operation........................................... 6-3
Using the CFG RESET Switch at Power-On.................................................. 6-4
Updating the Firmware.................................................................................................. 6-5
Appendix A
PWR/RDY LED Signaling
Appendix B
Troubleshooting and Common Questions
Appendix C
Specifications
Appendix D
Technical Support Resources
Glossary
Index