Starting/Pausing Playback
To start the playback of the loaded track:
• Press the Play/Pause button.
To pause the playback:
• Press the Play/Pause button again.
Holding Track Playback
You can use the Jog Wheel to hold the playback of the track, just like a record on a turntable:
1. Touch the top plate of the Jog Wheel and keep it hold.
The playback of the track holds immediately.
2. Release the top plate to let go playback.
Scratching the Track
You can use the Jog Wheel to perform scratch routines on the track:
1. Touch and hold the top plate of the Jog Wheel + quickly turn it clockwise and counter-clock-
wise in slight movements.
You will noticeably hear the typical vinyl scratch sound.
2. Release the top plate to let go of playback.
Seeking in the Track
You can use the Jog Wheel to seek within the track:
• Touch the top plate of the Jog Wheel + turn it clockwise or counter-clockwise.
Upon turning the Jog Wheel the track now quickly winds forward or backward, respectively.
To seek in bigger steps through the track:
• Press and hold SHIFT + turn the Jog Wheel clockwise or counter-clockwise.
Cueing the Track using the CUE Button
• When pressing and holding CUE button, the playback continues from the position of the float-
ing Cue Point as long as the CUE button is kept depressed.
• When releasing the CUE button, the playback position jumps back to the Cue Point and play-
back stops immediately.
• When pressing and holding the CUE button + later pressing the Play/Pause button, the play-
back continues as normal.
7.3. Adjusting Volume Levels
When mixing tracks you need to make sure that the volumes of both tracks are at the same level
for flawless transitions. For this, you can define the volume level for the incoming audio signal into
Tutorials
27
To Next Page
Loading...
Need help?
General
