Native Instruments Traktor Kontrol Z2 - Using the Z2 with TRAKTOR (TRAKTOR Mode); Basics

2.3.4 Select Your Hardware Drivers
After defining/confirming the program's installation path, you will be presented with a driver
selection screen. It is recommended to select all drivers from the driver selection screen unless
you have a specific reason to deselect a driver (such as if the driver is already installed on your
computer, or you are very sure you will never use the device with TRAKTOR).
1. Make sure to select the TRAKTOR KONTROL Z2 driver from the driver selection screen.
2. Click Next to proceed.
2.3.5 Complete the Software Installation
Once you have selected the driver and confirmed your selection, you will be forwarded to the
last screen of the installation program.
The final screen of the installation program.
Software Installation
Installation on Windows
TRAKTOR KONTROL Z2 - Setup Guide - 17